Coupling, Double Beam, Bore 1/2×1/2 In

                Motion Control Shaft Couplings Zero backlash Transmit low reactionary loads on bearings Nonlubricated couplings for applications where 2 shafts must move at the same speed, to the same location. Maintain constant velocity and provide protection from misalignment and corrosive elements. Suitable for light-duty applications with torque ratings less than 50 in.-lb., low inertia, and the capability of cyclic (repeated stop/stop/reverse) activity. Use in applications with a fractional electric motor driver, such as shaft encoders, medical equipment, servo devices, robots, linear and ball screw actuators, step motors, light-duty pumps and metering devices, plotters, positioning tables, computers, and radar. Double-Beam Clamp, ADB Series Max. rpm: 10, 000 Max. temp: 200°F (93°C) High torque capacity. 2 flex points provide the largest capacity for misalignment. This listing is for each. Technical Specification Item - Motion Control Couplings Motion Control Coupling Shaft Locking Type - Couplings 1 Piece Clamp Bore Dia. 1/2 in x 1/2 in Rated Torque 38 in-lb Max. RPM 10, 000 RPM Outside Dia. 1.252 in Overall Length 2.25 in Material - Couplings Aluminum Min. Bore (In.) 0.394 in Min. Bore (mm) 10.0 Max. Bore (In.) 0.748 in Max. Bore (mm) 19 mm Hub Dia. 1.252 in Length through Bore 0.63 in Screw Type Clamp Screw Screw Size M4 Max. Angular Misalignment 7 Degrees Max. Parallel Misalignment (In.) 0.02 in Max. Axial Misalignment (In.) +/-0.010 Max. Temp. 200 Degrees F Finish Anodized Aluminum Size ADB6